meinGuide

The purpose of this identifier.

Allows the appropriate identifier for a particular context of use to be selected from among a set of identifiers.

Applications can assume that an identifier is permanent unless it explicitly says that it is temporary.

Identifies the purpose for this identifier, if known .

A coded type for the identifier that can be used to determine which identifier to use for a specific purpose.

Allows users to make use of identifiers when the identifier system is not known.

This element deals only with general categories of identifiers. It SHOULD not be used for codes that correspond 1..1 with the Identifier.system. Some identifiers may fall into multiple categories due to common usage. Where the system is known, a type is unnecessary because the type is always part of the system definition. However systems often need to handle identifiers where the system is not known. There is not a 1:1 relationship between type and system, since many different systems have the same type.

A coded type for an identifier that can be used to determine which identifier to use for a specific purpose.

Time period during which identifier is/was valid for use.

A Period specifies a range of time; the context of use will specify whether the entire range applies (e.g. "the patient was an inpatient of the hospital for this time range") or one value from the range applies (e.g. "give to the patient between these two times").

Period is not used for a duration (a measure of elapsed time). See Duration.

Organization that issued/manages the identifier.

The Identifier.assigner may omit the .reference element and only contain a .display element reflecting the name or other textual information about the assigning organization.

The purpose of this identifier.

Allows the appropriate identifier for a particular context of use to be selected from among a set of identifiers.

Applications can assume that an identifier is permanent unless it explicitly says that it is temporary.

Identifies the purpose for this identifier, if known .

A coded type for the identifier that can be used to determine which identifier to use for a specific purpose.

Allows users to make use of identifiers when the identifier system is not known.

This element deals only with general categories of identifiers. It SHOULD not be used for codes that correspond 1..1 with the Identifier.system. Some identifiers may fall into multiple categories due to common usage. Where the system is known, a type is unnecessary because the type is always part of the system definition. However systems often need to handle identifiers where the system is not known. There is not a 1:1 relationship between type and system, since many different systems have the same type.

A coded type for an identifier that can be used to determine which identifier to use for a specific purpose.

Time period during which identifier is/was valid for use.

A Period specifies a range of time; the context of use will specify whether the entire range applies (e.g. "the patient was an inpatient of the hospital for this time range") or one value from the range applies (e.g. "give to the patient between these two times").

Period is not used for a duration (a measure of elapsed time). See Duration.

Organization that issued/manages the identifier.

The Identifier.assigner may omit the .reference element and only contain a .display element reflecting the name or other textual information about the assigning organization.

Whether this patient record is in active use. Many systems use this property to mark as non-current patients, such as those that have not been seen for a period of time based on an organization's business rules.

It is often used to filter patient lists to exclude inactive patients

Deceased patients may also be marked as inactive for the same reasons, but may be active for some time after death.

Need to be able to mark a patient record as not to be used because it was created in error.

If a record is inactive, and linked to an active record, then future patient/record updates should occur on the other patient.

This resource is generally assumed to be active if no value is provided for the active element

Identifies the purpose for this name.

Allows the appropriate name for a particular context of use to be selected from among a set of names.

Applications can assume that a name is current unless it explicitly says that it is temporary or old.

The use of a human name.

Specifies the entire name as it should be displayed e.g. on an application UI. This may be provided instead of or as well as the specific parts.

A renderable, unencoded form.

Can provide both a text representation and parts. Applications updating a name SHALL ensure that when both text and parts are present, no content is included in the text that isn't found in a part.

Part of the name that is acquired as a title due to academic, legal, employment or nobility status, etc. and that appears at the start of the name.

Note that FHIR strings SHALL NOT exceed 1MB in size

Part of the name that is acquired as a title due to academic, legal, employment or nobility status, etc. and that appears at the end of the name.

Note that FHIR strings SHALL NOT exceed 1MB in size

Indicates the period of time when this name was valid for the named person.

Allows names to be placed in historical context.

A Period specifies a range of time; the context of use will specify whether the entire range applies (e.g. "the patient was an inpatient of the hospital for this time range") or one value from the range applies (e.g. "give to the patient between these two times").

Period is not used for a duration (a measure of elapsed time). See Duration.

A contact detail (e.g. a telephone number or an email address) by which the individual may be contacted.

People have (primary) ways to contact them in some way such as phone, email.

A Patient may have multiple ways to be contacted with different uses or applicable periods. May need to have options for contacting the person urgently and also to help with identification. The address might not go directly to the individual, but may reach another party that is able to proxy for the patient (i.e. home phone, or pet owner's phone).

The date of birth for the individual.

Age of the individual drives many clinical processes.

At least an estimated year should be provided as a guess if the real DOB is unknown There is a standard extension "patient-birthTime" available that should be used where Time is required (such as in maternity/infant care systems).

Optional Extension Element - found in all resources.

There can be no stigma associated with the use of extensions by any application, project, or standard - regardless of the institution or jurisdiction that uses or defines the extensions. The use of extensions is what allows the FHIR specification to retain a core level of simplicity for everyone.

The purpose of this address.

Allows an appropriate address to be chosen from a list of many.

Applications can assume that an address is current unless it explicitly says that it is temporary or old.

The use of an address.

Distinguishes between physical addresses (those you can visit) and mailing addresses (e.g. PO Boxes and care-of addresses). Most addresses are both.

The definition of Address states that "address is intended to describe postal addresses, not physical locations". However, many applications track whether an address has a dual purpose of being a location that can be visited as well as being a valid delivery destination, and Postal addresses are often used as proxies for physical locations (also see the Location resource).

The type of an address (physical / postal).

Specifies the entire address as it should be displayed e.g. on a postal label. This may be provided instead of or as well as the specific parts.

A renderable, unencoded form.

Can provide both a text representation and parts. Applications updating an address SHALL ensure that when both text and parts are present, no content is included in the text that isn't found in a part.

The name of the administrative area (county).

District is sometimes known as county, but in some regions 'county' is used in place of city (municipality), so county name should be conveyed in city instead.

Sub-unit of a country with limited sovereignty in a federally organized country. A code may be used if codes are in common use (e.g. US 2 letter state codes).

Note that FHIR strings SHALL NOT exceed 1MB in size

A postal code designating a region defined by the postal service.

Note that FHIR strings SHALL NOT exceed 1MB in size

Time period when address was/is in use.

Allows addresses to be placed in historical context.

A Period specifies a range of time; the context of use will specify whether the entire range applies (e.g. "the patient was an inpatient of the hospital for this time range") or one value from the range applies (e.g. "give to the patient between these two times").

Period is not used for a duration (a measure of elapsed time). See Duration.

This field contains a patient's most recent marital (civil) status.

Most, if not all systems capture it.

Not all terminology uses fit this general pattern. In some cases, models should not use CodeableConcept and use Coding directly and provide their own structure for managing text, codings, translations and the relationship between elements and pre- and post-coordination.

The domestic partnership status of a person.

Image of the patient.

Many EHR systems have the capability to capture an image of the patient. Fits with newer social media usage too.

Guidelines:

• Use id photos, not clinical photos.
• Limit dimensions to thumbnail.
• Keep byte count low to ease resource updates.

The nature of the relationship between the patient and the contact person.

Used to determine which contact person is the most relevant to approach, depending on circumstances.

Not all terminology uses fit this general pattern. In some cases, models should not use CodeableConcept and use Coding directly and provide their own structure for managing text, codings, translations and the relationship between elements and pre- and post-coordination.

The nature of the relationship between a patient and a contact person for that patient.

A name associated with the contact person.

Contact persons need to be identified by name, but it is uncommon to need details about multiple other names for that contact person.

Names may be changed, or repudiated, or people may have different names in different contexts. Names may be divided into parts of different type that have variable significance depending on context, though the division into parts does not always matter. With personal names, the different parts might or might not be imbued with some implicit meaning; various cultures associate different importance with the name parts and the degree to which systems must care about name parts around the world varies widely.

A contact detail for the person, e.g. a telephone number or an email address.

People have (primary) ways to contact them in some way such as phone, email.

Contact may have multiple ways to be contacted with different uses or applicable periods. May need to have options for contacting the person urgently, and also to help with identification.

Administrative Gender - the gender that the contact person is considered to have for administration and record keeping purposes.

Needed to address the person correctly.

Note that FHIR strings SHALL NOT exceed 1MB in size

The gender of a person used for administrative purposes.

Organization on behalf of which the contact is acting or for which the contact is working.

For guardians or business related contacts, the organization is relevant.

References SHALL be a reference to an actual FHIR resource, and SHALL be resolveable (allowing for access control, temporary unavailability, etc.). Resolution can be either by retrieval from the URL, or, where applicable by resource type, by treating an absolute reference as a canonical URL and looking it up in a local registry/repository.

The period during which this contact person or organization is valid to be contacted relating to this patient.

A Period specifies a range of time; the context of use will specify whether the entire range applies (e.g. "the patient was an inpatient of the hospital for this time range") or one value from the range applies (e.g. "give to the patient between these two times").

Period is not used for a duration (a measure of elapsed time). See Duration.

The ISO-639-1 alpha 2 code in lower case for the language, optionally followed by a hyphen and the ISO-3166-1 alpha 2 code for the region in upper case; e.g. "en" for English, or "en-US" for American English versus "en-EN" for England English.

Most systems in multilingual countries will want to convey language. Not all systems actually need the regional dialect.

The structure aa-BB with this exact casing is one the most widely used notations for locale. However not all systems actually code this but instead have it as free text. Hence CodeableConcept instead of code as the data type.

A human language.

Indicates whether or not the patient prefers this language (over other languages he masters up a certain level).

People that master multiple languages up to certain level may prefer one or more, i.e. feel more confident in communicating in a particular language making other languages sort of a fall back method.

This language is specifically identified for communicating healthcare information.

Patient's nominated care provider.

This may be the primary care provider (in a GP context), or it may be a patient nominated care manager in a community/disability setting, or even organization that will provide people to perform the care provider roles. It is not to be used to record Care Teams, these should be in a CareTeam resource that may be linked to the CarePlan or EpisodeOfCare resources. Multiple GPs may be recorded against the patient for various reasons, such as a student that has his home GP listed along with the GP at university during the school semesters, or a "fly-in/fly-out" worker that has the onsite GP also included with his home GP to remain aware of medical issues.

Jurisdictions may decide that they can profile this down to 1 if desired, or 1 per type.

Organization that is the custodian of the patient record.

Need to know who recognizes this patient record, manages and updates it.

There is only one managing organization for a specific patient record. Other organizations will have their own Patient record, and may use the Link property to join the records together (or a Person resource which can include confidence ratings for the association).

The other patient resource that the link refers to.

Referencing a RelatedPerson here removes the need to use a Person record to associate a Patient and RelatedPerson as the same individual.

The type of link between this patient resource and another patient resource.

Note that FHIR strings SHALL NOT exceed 1MB in size

The type of link between this patient resource and another patient resource.